Mating-type recognition in T. thermophila.

(A) Example of self and non-self mating-type recognition. When one cell of mating type I encounters another, costimulation and mating do not occur. When a cell of mating type I encounters a cell of another mating type (II–VII), the cells enter the costimulation stage and go on to form a pair. (B) Two typical phenotypes of the costimulation stage are Tip transformation and Con-A receptor appearance. Yellow dashed circle, transformed cell tip (center, single cell) or pairing junction (right, cell pair). Note that Tip transformation may become less obvious after Con-A staining. (C) MTA and MTB gene structure and MTA and MTB protein domain information (Cervantes et al., 2013). MTA and MTB form a head-to-head gene pair. For each gene, the terminal exon is shared by all mating types and the remainder is mating-type-specific (the sequence differs for each mating type). The mating-type-specific region of each protein is predicted to be extracellular.

Mating-type proteins are essential for mating-type recognition.

(A) Experimental procedure for the costimulation experiments. Starved WT cells of mating types V (WT-V) and VII (WT-VII) were separately pre-incubated with the indicated mating type VI mutant (9 : 1 ratio) for 30 min and then the pre-incubated cells were mixed at a 1 : 1 ratio. Note that before mixing the costimulated cells, any potentially pairing cells were separated by shaking. (B) Effect of pre-incubation with ΔMTA and ΔMTB on the rate of pair formation. Each experiment was repeated three times, with > 100 pairs counted at each time point. Matched two-way ANOVA was used for the statistical analysis. N.S., not significant; *, P < 0.05; **, P < 0.01; ***, P < 0.001; ****, P < 0.0001. Unpaired mutants were excluded when calculating the pairing rate (see Materials and Methods). (C) Tip transformation, a hallmark of costimulation. Costimulated cells from two different WT strains are shown because their tips have slightly different shapes. Each strain was pre-incubated with the strain shown in subscript. Yellow dashed circle, transformed cell tip. (D) Appearance of Con-A receptors, another hallmark of costimulation. In all, ∼90% cells show Con-A receptor fluorescence (panels 4, 5 and 9). The low percentage of cells (7%) with fluorescence in panel 7 were probably WT cells, which comprised 10% of the pre-incubation culture. Each strain was pre-incubated with the strain shown in subscript. Yellow dashed circle, Con-A receptor fluorescence.

Proteins that interact with MTA and MTB.

(A) Construction of HA-tagged strains. All of the tagged strains mated like WT cells. (B) Statistical analysis of IP-MS data. A total of 13 experiments were carried out. WT samples (untagged) were run in parallel for each sample. All 13 WT controls were combined as the background control. Red dot, high-confidence interaction; dark gray dot, low-confidence interaction. Gene identifiers are summarized in Figure 3–Source data 2. Note that the wash buffer contained 1% Triton X-100 and 600 mM NaCl. (C) Interaction network based on IP-MS data. Orange oval, bait; blue oval, high-confidence prey; light gray dot, low-confidence prey; black line, high-confidence interaction; dark gray dashed line, low-confidence interaction; light gray dotted line, interaction supported by a few peptides (these proteins were shown because their coding genes are coexpressed with MTA and MTB and deleting them affects mating behavior). (D) Diagram of functional domain annotation of MTRC components. GFR, growth factor receptor domain; PLF, pectin lyase fold; Poly-E, poly-glutamic acid region; NTH, P-loop-containing nucleotide triphosphate hydrolase. (E) Expression profiles of genes whose protein products were identified by IP-MS as potentially components of the MTRC. Expression data is derived from TetraFGD (Xiong et al., 2011).

Mating-type proteins are cell surface proteins but do not localize to cilia.

(A) Fractionation of MTA7-HA cells (please see Figure 4–figure supplement 1A for the experimental process). Red arrowhead, MTA7-HA; F, flow through; P, pellet; R, resin; S, supernatant; W, wash. The MTA signal is undetectable until S3 (enriched membrane proteins), and only appears after affinity chromatography (R). (B) WB analysis of cell surface proteins. Red arrowhead, MTA7-HA; M, marker; C, negative control (unbiotinylated). (C) Cilia isolation and purification. (D) WB analysis of IP products of membrane and ciliary proteins. Mem, membrane; R, resin; S, supernatant. The same amount of MTA7-HA cells was used for the membrane and ciliary protein IPs. The full blot is shown in Figure 4–figure supplement 1B. (E) Construction scheme for eGFP-tagged MTB2 strains. (F) Costimulated MTB2-eGFP cell. (G) Paired MTB2-eGFP cell. To induce MTB2-eGFP overexpression, cells were treated with 10 ng/ml Cd2+ for 5 h. Green, eGFP signal; red, tubulin signal; yellow dashed line, cell outline. The focal plane of these images is the cell surface.

Stimulation experiments using MTAxc and/or MTBxc.

(A) WT cells were treated with MTAxc and/or MTBxc proteins (30 pg/ml, 1 h) of different mating-type specificities. WT-VI cells were treated with MTA/B7xc protein, and WT-VII cells were treated with MTA/B6xc protein. Treated cells were washed twice before mixing to remove residual proteins from the starvation medium. Note that the starvation medium used for washing had been previously used for cell starvation because T. thermophila cells secrete mating-essential factors during starvation (Adair et al., 1978). Each experiment was repeated five times. (B, C) The percentages of cells paired at 60 min (B) and 75 min (C) were used for the statistical analysis (method described in Figure 2B). (D) WT cells (mating types VI and VII) were treated with MTAxc and/or MTBxc proteins of the same mating-type specificity (as described in (A)). (E, F) The percentages of cells paired at 75 min (E) and 240 min (F) were used for the statistical analysis (method described in Figure 2B).

Results of treatment with either MTAxc or MTBxc proteins.

(A–F) Dose–response effect of treatment with MTA6xc or MTB6xc protein. (A–C) MTA6xc results. (D–F) MTB6xc results. Cells of mating types I and VII were used for these experiments. Experimental and statistical methods were as described for Figure 5, except for protein concentrations. (G–J) MTA6xc or MTB6xc proteins affect the mating of various combinations of other WT mating types. (G) MTA6xc results. Both mating partners were treated. (H) MTB6xc results. Both mating partners were treated. (I) MTA6xc results. Cells of only one mating type were treated. Note that mating type VI cells were used in these experiments. (J) MTB6xc results. Note that mating type VI cells were used in these experiments. Experimental and statistical methods were as described for Figure 5. Red superscript “T” in (I) and (J) indicate the strain treated with MTA6xc or MTB6xc. The mating types used in each experiment is shown in the top-left corner.

T. thermophila lifecycle.

T. thermophila has seven mating types. Cells divide asexually when nutrition is adequate. After starvation, cells of any two different mating types recognize each other and enter a pre-conjugation stage called costimulation. In this stage, cells first become round (Fujishima et al., 1993); subsequently, their cell tips are transformed into a curved shape (Wolfe & Grimes, 1979) and the Con-A receptor becomes detectable (Wolfe & Feng, 1988; Wolfe et al., 1986). Costimulated cells then form pairs via a rotating behavior (Video S1, S2). During the sexual life cycle (conjugation), cells undergo a series of sexual events such as meiosis and reciprocal fertilization (for details refer to (Orias et al., 2011)). Exconjugants (separated pairs) finally form parent-like progeny when nutrition becomes available, but remain sexually immature. After ∼60 fissions, cells mature and their mating type is determined and becomes fixed (for details of mating-type determination, refer to (Cervantes et al., 2013; Lin & Yao, 2020; Orias et al., 2017)).

Mating-type gene deletion strains do not costimulate WT cells. (A) Pre-incubation results predicted by a simple receptor–ligand model of mating-type recognition, in which one mating-type protein is designed ligand (L) and the other receptor (R). The type of cell used to costimulate is shown on the left. The expected result of costimulation if T. thermophila were to use non-self mating-type recognition (1, 3, 5) or self mating-type recognition (2, 4, 6). If this simple model were true, deleting the receptor would have a different effect on costimulation to deleting the ligand. However, the experimental results showed that neither ΔMTA nor ΔMTB can fully transmit/receive mating signal to/from WT cells. Therefore, mating-type recognition in T. thermophila does not occur via the simple receptor–ligand binding mechanism. Costim, costimulation. (B) Pre-incubation with ΔMTA or ΔMTB does not influence the pairing rate. The experimental method was as described in Figure 2A except that the pre-incubation time was 16 h.

Cell fractionation MTA7-HA cells.

(A) Experimental process for cell fractionation. (B) Affinity purification results of the soluble pool (S2, shown in panel A) and ciliary protein. C+, positive control (i.e., IP product of MTA7-HA cell membrane); R, resin; S, supernatant. No MTA7-HA signal was detected in the soluble pool or in ciliary protein samples, even after affinity purification.

Confocal images of ciliary sections and cell interior sections of MTB2-eGFP cells.

(A) No MTB2-eGFP signal was associated with cilia. (B) In the cell interior section, MTB2-eGFP protein was detected on the plasma membrane and in intracellular structures, probably the ER and Golgi.

Expression and purification of extracellular regions of mating-type proteins.

(A) Schematic diagram showing truncated and full-sized proteins. (B–E) Size-exclusion chromatography for MTA6xc (B), MTB6xc (C), MTA7xc (D), and MTB7xc (E). Left, elution profile; right, Coomassie blue staining. In, input; M, marker.

Treatment with MTA6xc and/or MTB6xc proteins fails to induce costimulation.

(A) Tip transformation. Yellow dashed circle, transformed cell tip. (B) Con-A receptor appearance. Yellow dashed circle, Con-A signal. Cells of mating type VII were used for these experiments.