Cell Signaling: The many states of STIM1
Harnessing single-molecule FRET illuminates the structural changes necessary for a protein to fine-tune the influx of calcium when reserves inside a cell run low.
- Institute of Biophysics, Johannes Kepler University Linz, Austria
Over the past decades, the humble calcium ion has emerged as a crucial intracellular messenger that participates in an impressively diverse array of biological processes, from fertilization to programmed cell death. It plays a key role in cells across the body, helping to activate the immune system, release neurotransmitters, and trigger muscle contractions. Imbalances in the concentration of calcium inside a cell leads to chaotic responses and, in some cases, to diseases that can sometimes be fatal (Feske et al., 2006; Lacruz and Feske, 2015; Morin et al., 2020).
The flow of calcium ions into cells is therefore tightly regulated, including by a system known as SOCE (short for store operated calcium entry), which has recently been gaining attention (Prakriya and Lewis, 2015). When calcium levels drop inside an intracellular storage compartment called the endoplasmic reticulum, SOCE increases the intake of calcium ions across the plasma membrane that separates the cell from its environment. The system relies on two proteins: Orai, a calcium-selective channel studded through the plasma membrane; and the stromal interaction molecule (STIM1), located in the membrane surrounding the endoplasmic reticulum (Prakriya and Lewis, 2015). STIM1 can sense the levels of calcium inside the reticulum and activate Orai when these get low. For precisely the right amount of calcium to be ushered into the cell, STIM1 and Orai must be tightly regulated. Now, in eLife, Richard Lewis and colleagues based at Stanford University School of Medicine – including Stijn van Dorp as first author – report impressive insights into the conformations and dynamics of STIM1 (van Dorp et al., 2021).
In its resting state, STIM1 forms a dimer that binds to calcium ions present in high concentrations inside the reticulum and adopts a tightly packed conformation (Figure 1A, left). One tail of the STIM1 protein features three large ‘coiled-coil’ domains (CC1, 2 and 3), which are stabilized in the resting, tight state via a specific type of ‘coiled-coil’ interaction (Fahrner et al., 2020). Extracellular signals such as growth factors, hormones or foreign molecules can trigger calcium-dependent signaling pathways and therefore deplete reticulum calcium reserves. As a result (Zhou et al., 2013), STIM1 loses the ions it is bound to, and undergoes a series of conformational changes that culminate in its cytoplasmic portion (which is in contact with the inside of the cell) being extended, and increasing in length (Figure 1A, right). This elongated STIM1 stretches to the edge of the cell, reaching junctions that bring together the plasma membrane and the reticulum. Once there, it encounters and couples to Orai, triggering the channel to open and allow calcium ions to enter the cell (Prakriya and Lewis, 2015).
Figure 1
Conformation and dynamics of STIM1.
(A) Models of dimeric STIM1 conformational states. (Left) When the endoplasmic reticulum (ER) calcium store is full, a subdomain of CC1 (called α1) and the CC2-CC3 domains of CAD form a tight coiled-coil interaction (represented by small black double arrows), which is characteristic of the tight, resting state of STIM1 and prevents binding to Orai. (Middle) Upon calcium store depletion, the STIM1 domains inside the ER (pink) lose their bound Ca2+ ions (red spheres), causing the regions to interact with one another and eliciting an interaction (double arrows) between the transmembrane domains (TM; dark green) of the dimerized STIM proteins. These rearrangements likely lead to an intermediate state in which the CC1α1-CAD coiled-coil interaction is released (represented by curved arrows), and CAD is projected towards the plasma membrane while CC1α1 comes into close proximity to the other two subdomains of CC1 (α2 and α3). (Right) CC1 then fully unfolds into its extended state, allowing CAD to interact with and activate Orai. (B) (Top) Schematic showing the dimeric STIM1 C-terminus structure derived by van Dorp et al. from smFRET data. Double arrows between the domains (orange and grey) indicate switching of CC1α1-CAD interaction between intramolecular (’cis‘) and intermolecular (’trans’) within the STIM1 C-terminus dimer. (Bottom) The mutation associated with Stormorken syndrome disrupts the connection between CC1α1 and CAD, as revealed by the smFRET data. Dark grey arrows show how the position of the STIM1 domains changes, and red crosses mark the position of the mutation (called R304W) at the end of the CC1α2 domain. The STIM1 C-terminal regions downstream of CAD were omitted for simplicity.
Image credit: Herwig Grabmayr (CC BY 4.0).
The CC2 and CC3 domains of STIM1, called CAD (or SOAR), form the Orai-activating region, the structure of which has been examined in dimeric form using X-ray crystallography (Park et al., 2009; Yang et al., 2012; Yuan et al., 2009); yet many aspects remain unknown about how STIM1 can switch between a resting and activated state, how it can activate Orai, and in particular how CC1 interacts with CAD to regulate the activity of this calcium sensor. To shed light on these dynamics, the team harnessed single-molecule FRET microscopy (smFRET), a biophysical technique that allows scientists to measure distances between amino acids using fluorescent compounds; this approach was applied to the C-terminus of STIM1. The resulting data fit well with the previously reported CAD crystal structure, while adding details on the orientation of the domain, in particular its Orai binding region (Baraniak et al., 2020).
Consistent with a recent report, the data suggests that CAD sequesters the Orai binding region near the reticulum membrane (Figure 1A, left; 1B, top; Höglinger et al., 2021). The experiments showed that the coiled-coil domains CC1 and CC3, located on the cytoplasmic side of the reticulum membrane, interact to create an inhibitory clamp that stabilizes STIM1 in its compact, resting state (Figure 1A, left). Previously, an intramolecular, ‘cis’ CC1/ CC3 interaction had been assumed (Fahrner et al., 2014; Ma et al., 2015), but the smFRET data suggested both a switching intermolecular, ‘trans’ as well as intramolecular, ‘cis’ interaction within a STIM1 dimer (Figure 1B, top).
Furthermore, van Dorp et al. focused on the CC1 domain and its three CC1α1, α2 and α3 subregions, confirming the findings of previous studies (Fahrner et al., 2014). Another group used nuclear magnetic resonance spectroscopy to examine both the whole CC1 domain, and how its subregions interact to affect STIM1 activation (Rathner et al., 2021). The structure identified in this study, however, was not observed by van Dorp et al., who suggest it is an intermediate state following STIM1 activation (Figure 1A, middle). Experiments artificially linking together nearby amino acids gave additional structural information about the CC1 subdomains, showing that activated STIM1 appears to shift to a fully elongated conformation to couple to Orai (Figure 1A, right).
Further insights into STIM1 structures were then provided in a disease context, as van Dorp et al. imaged a mutated version of STIM1 associated with a rare condition known as Stormorken syndrome (Morin et al., 2020). The smFRET approach revealed that this change had substantial impact on the conformation of STIM1 (Figure 1B, bottom). In particular, it destabilized the resting, tight state of STIM1 C-terminus by releasing the inhibitory clamp between CC1 and CC3 (Figure 1B).
Without high-resolution structural information, smFRET is an excellent method to grasp the configuration and dynamic of proteins – as long as, of course, the fluorescent molecules required for the technique do not disturb these interactions. Applying this method to a whole STIM1 protein reconstituted into a lipid vesicle would further improve the approach, allowing researchers to assess STIM1 conformational changes under more physiological conditions. How the protein rearranges itself when calcium levels drop in the reticulum could be visualized on both sides of the membrane of this compartment. Orai domains (or even the full channel) could be reconstituted in other vesicles, and then used to probe the interaction between STIM1 and Orai. A finer understanding of the conformational changes of STIM1 as it couples to Orai will shed light on how calcium levels are regulated in both healthy and diseased cells.
References
-
The intricate coupling between STIM proteins and Orai channelsCurrent Opinion in Physiology 17:106–114.https://doi.org/10.1016/j.cophys.2020.07.018
-
A coiled-coil clamp controls both conformation and clustering of stromal interaction molecule 1 (STIM1)The Journal of Biological Chemistry 289:33231–33244.https://doi.org/10.1074/jbc.M114.610022
-
Mechanism of STIM activationCurrent Opinion in Physiology 17:74–79.https://doi.org/10.1016/j.cophys.2020.07.006
-
Defects in the STIM1 SOARα2 domain affect multiple steps in the CRAC channel activation cascadeCellular and Molecular Life Sciences 78:6645–6667.https://doi.org/10.1007/s00018-021-03933-4
-
Diseases caused by mutations in ORAI1 and STIM1Annals of the New York Academy of Sciences 1356:45–79.https://doi.org/10.1111/nyas.12938
-
Inside-out Ca(2+) signalling prompted by STIM1 conformational switchNature Communications 6:7826.https://doi.org/10.1038/ncomms8826
-
Store-operated calcium channelsPhysiological Reviews 95:1383–1436.https://doi.org/10.1152/physrev.00020.2014
-
Interhelical interactions within the STIM1 CC1 domain modulate CRAC channel activationNature Chemical Biology 17:196–204.https://doi.org/10.1038/s41589-020-00672-8
-
SOAR and the polybasic STIM1 domains gate and regulate Orai channelsNature Cell Biology 11:337–343.https://doi.org/10.1038/ncb1842
-
Initial activation of STIM1, the regulator of store-operated calcium entryNature Structural & Molecular Biology 20:973–981.https://doi.org/10.1038/nsmb.2625
Article and author information
Author details
Publication history
- Version of Record published: December 7, 2021 (version 1)
Copyright
© 2021, Fahrner and Romanin
This article is distributed under the terms of the Creative Commons Attribution License, which permits unrestricted use and redistribution provided that the original author and source are credited.
Metrics
-
- 1,070
- views
-
- 125
- downloads
-
- 1
- citations
Views, downloads and citations are aggregated across all versions of this paper published by eLife.
Download links
A two-part list of links to download the article, or parts of the article, in various formats.
Downloads (link to download the article as PDF)
Open citations (links to open the citations from this article in various online reference manager services)
Cite this article (links to download the citations from this article in formats compatible with various reference manager tools)
Cell Signaling: The many states of STIM1
eLife 10:e75174.
https://doi.org/10.7554/eLife.75174
Further reading
-
- Structural Biology and Molecular Biophysics
Regulated hydrolysis of the phosphoinositide phosphatidylinositol(4,5)-bis-phosphate to diacylglycerol and inositol-1,4,5-P3 defines a major eukaryotic pathway for translation of extracellular cues to intracellular signaling circuits. Members of the lipid-activated protein kinase C isoenzyme family (PKCs) play central roles in this signaling circuit. One of the regulatory mechanisms employed to downregulate stimulated PKC activity is via a proteasome-dependent degradation pathway that is potentiated by peptidyl-prolyl isomerase Pin1. Here, we show that contrary to prevailing models, Pin1 does not regulate conventional PKC isoforms α and βII via a canonical cis-trans isomerization of the peptidyl-prolyl bond. Rather, Pin1 acts as a PKC binding partner that controls PKC activity via sequestration of the C-terminal tail of the kinase. The high-resolution structure of full-length Pin1 complexed to the C-terminal tail of PKCβII reveals that a novel bivalent interaction mode underlies the non-catalytic mode of Pin1 action. Specifically, Pin1 adopts a conformation in which it uses the WW and PPIase domains to engage two conserved phosphorylated PKC motifs, the turn motif and hydrophobic motif, respectively. Hydrophobic motif is a non-canonical Pin1-interacting element. The structural information combined with the results of extensive binding studies and experiments in cultured cells suggest that non-catalytic mechanisms represent unappreciated modes of Pin1-mediated regulation of AGC kinases and other key enzymes/substrates.
-
- Structural Biology and Molecular Biophysics
Roco proteins entered the limelight after mutations in human LRRK2 were identified as a major cause of familial Parkinson’s disease. LRRK2 is a large and complex protein combining a GTPase and protein kinase activity, and disease mutations increase the kinase activity, while presumably decreasing the GTPase activity. Although a cross-communication between both catalytic activities has been suggested, the underlying mechanisms and the regulatory role of the GTPase domain remain unknown. Several structures of LRRK2 have been reported, but structures of Roco proteins in their activated GTP-bound state are lacking. Here, we use single-particle cryo-electron microscopy to solve the structure of a bacterial Roco protein (CtRoco) in its GTP-bound state, aided by two conformation-specific nanobodies: NbRoco1 and NbRoco2. This structure presents CtRoco in an active monomeric state, featuring a very large GTP-induced conformational change using the LRR-Roc linker as a hinge. Furthermore, this structure shows how NbRoco1 and NbRoco2 collaborate to activate CtRoco in an allosteric way. Altogether, our data provide important new insights into the activation mechanism of Roco proteins, with relevance to LRRK2 regulation, and suggest new routes for the allosteric modulation of their GTPase activity.
